Table of Contents
Advertisement
Operation instruction
MODE FAN
TEMP
CLOCK
TIMER
ROOM
HEAT FILTER RESET
ON/OFF
3.Set time
Press the time adjusting button
*
Each press, the set time increases 10 minutes. If depress the button, the
time will increase rapidly.
*
Each press, the set time decreases 10 minutes. If depress the button, the time will
decrease rapidly.
This LCD will show the time set, the time can be adjusted within 24h.
(AM stands for morning, PM stands for afternoon).
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
At this time, the
*
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
Cancel TIMER
Press the TIMER button several times until the TIMER mode display
disappears.
Hints:.
After power failure, the clock should be calibrated again.
The wire controller has memory function, when you use this function for the
second time, if the time set is the same as the previous one, you just need to
choose the TIMER mode then press the SET button to confirm.
Before using TIMER function, calibrate the clock
first (referring to page 4). When you wake up in the
morning, before going back to home after work or
after going to bed, you can let your air conditioner
automatically turn on or turn off.
1.Turn on the unit
After turning on the unit, set the desired
SWING
working mode.
The LCD of the wire controller will show
working mode. (except for Timer, Sleep, Swing)
SET
SLEEP
2.Set of TIMER mode
RESET
Press the TIMER button to change the TIMER
mode, each press the TIMER mode will
change as the following sequence:
Then choose the timer mode as you need
(TIMER ON or TIMER OFF.)
At this time the
or
will not flash.
ON
OFF
*
*
*
Timer On/Off function
ON
OFF
AM
PM
TIMER ON TIMER OFF
"
ON
9
ON
OFF
Blank
AM
PM
TIMER ON-OFF
or
will flash.
"
"
"
OFF
Advertisement
Table of Contents
