Table of Contents
Advertisement
Operation instruction
Before using TIMER function, calibrate the clock first (referring to page 3). When you wake up in
the morning, before going back to home after work or after going to bed, you can let your air conditioner
automatically turn on or turn off.
Mode Fan Speed Swing
Temperature
Clock
Timer
**
Aux.Heat Fileter Reset
ON/OFF
3. Set time
Press the time adjusting button
Each press, the set time increases 10 minutes. If depress the button, the time will increase
rapidly.
Each press, the set time decreases 10 minutes. If depress the button, the time will decrease rapidly.
This LCD will show the time set, the time can be adjusted within 24h.
(AM stands for morning, PM stands for afternoon).
Confirm the time
4.
After calibration of the clock, press SET button to confirm time.
At this time, the ON or OFF will not flash.
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
Cancel TIMER
Press the TIMER button several times until the TIMER mode display
disappears.
Hints:.
After power failure, the clock should be calibrated again.
The wire controller has memory function, when you use this function
for the second time, if the time set is the same as the previous one, you
just need to choose the TIMER mode then press the SET button to confirm.
1. Turn on the unit
After turning on the unit, set the desired working mode.
The LCD of the wire controller will show working mode.
(except for Timer, Sleep, Swing)
2. Set of TIMER mode
Set
Press the TIMER button to change the TIMER mode,
each press the TIMER mode will change as the following
Sleep
sequence:
Reset
ON
AM
Timer On Timer Off
Then choose the timer mode as you need
(TIMER ON or TIMER OFF.)
At this time the ON or OFF will flash.
Timer On/Off function
OFF
ON
OFF
AM
PM
PM
Timer On-Off
Blank
Advertisement
Table of Contents
