Timer On/Off Function - Haier AU422XIBAA Service Manual

Timer ON/OFF Function

Set clock correctly before starting TIMER operation
A
TEMP
ON
OFF
SWING FAN
1
MODE SLEEP
HEALTH FRESH
CLOCK SET
3
TIMER HIGH/SO
2
FILTER
LIGHT LOCK
RESET CODE
Note:
After setting TIMER function, the remote controller displays TIMER time. If you want to see clock time,
just press CLOCK button once: clock time will be displayed (if you press the button again continuously,you
can adjust clock). 5 seconds later, the display will show TIMER time again.
1.Unit start
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
ON
12:00
AM
TIMER ON
Then select TIMER mode as needed (TIMER ON or TIMER OFF).
Now
ON
3.TIMER setting (press time adjust buttons
Every time the button is pressed, time increases 10 minuts.
If the button is kept pressed, time changes quickly.
4
Every time the button is pressed, time decreases 10 minuts.
If the button is kept pressed, time changes quickly.
It can be adjusted within 24 hours at will.
4.Confirm setting
After setting correct time, press SET button to confirm time. Now
or
ON OFF
Time displayed: unit starts or stops at X hour X min (TIMER ON
or TIMER OFF)
5.Cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
Hints:
After replacing batteries or if a power failure occurs, TIMER setting
must be reset.
Remote controller has memory function. When you use TIMER
mode next time, just press SET button after mode selection if timer
setting is the same as the previous one.
OFF ON
12:00 12:00
AM
PM
TIMER OFF TIMER ON-OFF
or will flash.
OFF
stop flashing.
blank
OFF
12:00
PM
)