Haier AP88NACBEA Operation Manual page 8

Operation instruction
MODE
TEMP
CLOCK
SET
TIMER
HEAT FILTER RESET
ON/OFF
When room temperature
is higher than set
temperature, unit in
COOLING operation.
Set temperature + 2*
Set temperature
When room temperature
reaches set temperature
+ 2*, the unit will
operate in mild
dehumidifying
operation.
In Heating operation, after start
the unit, the air conditioner will
sending warm air a moment
later to prevent the cold air
blowing out. In Dehumidifying,
when the room temperature drops
2* higher than the set
temperature, regardless the set fan
speed, the air conditioner will
intermittently operate in low fan
speed.
Hints:
The wire controller can memorize the working condition of each time. When
start the unit for the second time, just need to press ON/OFF button, the air
conditioner will work according to the previous working mode. (except for
Timer, Sleep and Swing)
Auto/Cooling/Dehumidifying/Heating operation
FAN SWING
SET
SLEEP
RESET
Ultra-low air flow
1 Turn on the unit
Press the ON/OFF button to turn on the
unit The LCD display of the wire
controller will show the previous
working state (except for TIMER,
SWING, SLEEP mode). The operation
indicator light on the wire controller
will light up.
2
Choose of working mode
Press MODE button, each press the
working mode will change as the
following sequence:
AUTO COOLING DEHUMIDIFYING HEATING FAN
then choose AUTO, COOLING,
DEHUMIDIFYING, HEATING operation.
Set temperature
3
Press the TEMP. SET button
*Each press , the set temperature will
increase 1 degree.
*Each press, the set temperature will
decrease 1 degree.
Set the desired temperature.
Adjusting FAN SPEED
4
Press the FAN SPEED button, for each
press, the fan speed will change as the
following sequence:
LOW FAN MED FAN
Choose the desired fan speed.
Turn off the unit
5
Press the ON/OFF button to turn off
the unit.
The wire controller only shows the clock
and room temperature.
7
AUTO
HIGH FAN AUTO