Name Of Parts - Haier AP88NACBEA Operation Manual

Name of Parts

1.ON/OFF button
Used to turn on/off unit
2.Temperature display
3.Clock display
4.Timer ON/OFF display
5.Humidity display
6.Air filter cleaning display
When there is too much dust
collected on the air inlet, the
wire controller will show
this display to remind the
user to clean the air inlet.
After cleaning and installation,
*
just press the air filter reset button.
7.Super/Soft operation display
8.Fan speed display
Low Fan Med Fan High Fan Auto
9.Auto Swing display
10.Health state display
11.Fresh air state display
12.Humidifying state display
Note:
This model does not have the following related display and function
1.
Non-electric heating type, there is no electric heating button
2.
display
16
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The
method of calibration is:
1.Press ì Clockî button, the Clock display ì AMî ì PMî will flash.
2.Press * or
to adjust time. For each press, the time will increase or decrease 1
minute. If depressing the button, the time will increase or decrease rapidly.
*
3.After confirming the time, press ì Setî button, ì AMî or ì PMî will stop flashing,
the clock will begin to work.
*
AUTO
SET
ROOM
13.Sleep state display
14.Network control display
15.Working mode display
Working Auto
mode operation
Wire
controller
16.Electric heating display
17.Operation mode button
Used to set working mode:
Auto, Cooling, Dehumidifying,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
19.Swing button
Auto
Used to set Auto Swing or
Fixed air sending direction
20.Temperature Setting button
Used to set temperature,
temperature range: 16*~30*
21.Clock button
Used to calibrate the time of
timer and clock
MODE FAN SWING
TEMP
CLOCK SET
TIMER SLEEP
HEAT FILTER RESET
RESET
ON/OFF
Cooling Dehumidifying Heating
operation operation operation
3
Wire Controller
22.Setting button
Used to confirm
the time of timer
and clock
23.Sleep button
Used to set Sleep
state or Power
Failure Resume
Function
24.Time Adjusting
button
Used to adjust the
time of timer and
clock
25.Reset button
Fan
When the wire
operation
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal
26.Air Filter Reset
button
After cleaning the
air inlet, press this
button, the unit
can start to operate
27.Timer button
Used to set the
mode of timer
28.Electric heating button
29.Lock state display
* 6 * 10 11 12
and electric heating
28
29