Table of Contents
Advertisement
Operation instruction
MODE
TEMP
CLOCK
SET
TIMER
HEAT
FILTER RESET
ON/OFF
3.
Set time
Press the time adjusting button
Each press, the set time increases 10 minutes. If depress the button, the time will
increase rapidly.
Each press, the set time decreases 10 minutes. If depress the button, the time will
decrease rapidly.
This LCD will show the time set, the time can be adjusted within 24h.
(The minimum interval is 10 minutes).
AM stands for morning, PM stands for afternoon
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
At this time, the
*
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
5.Cancel TIMER
Press the TIMER button several times until the TIMER mode display disappears.
Hints:.
After power failure, the clock should be calibrated again.
The remote controller has memory function, when you use this function for the second time,
if the time set is the same as the previous one, you just need to choose the TIMER mode then
press the SET button to confirm.
Before using TIMER function, calibrate the clock first.
1.Turn on the unit
After turning on the unit, set the desired working
mode.
FAN
SWING
The LCD will show working mode.
The power indicator light on the indoor unit will light up.
SET
2.Set of TIMER mode
SLEEP
Press the TIMER button to change the TIMER mode,
RESET
each press the TIMER mode will change as the following
sequence:
TIMER ON
Then choose the timer mode as need
(TIMER ON or TIMER OFF.)
At this time the
*
or
*
*
will not flash.
ON
OFF
Timer On/Off function
ON
OFF
AM
PM
TIMER OFF
*
*
*
or
ON
ON
OFF
Blank
AM
PM
TIMER ON-OFF
*
will flash.
OFF
11
Advertisement
Table of Contents
