Table of Contents
Advertisement
S
8 • R
ECTION
•
Make sure the hull drain plug is in place and
tight.
•
Clean bilge thoroughly if it was not done at
lay-up.
•
Check all engine fluid levels.
•
Check fuel lines for damage and/or leaks. Make
sure that they do not come into contact with
moving parts.
7. S
C
ECURITY
ONSIDERATIONS
Be conscious of the security of your boat.
Always remove the keys from the ignition, lock
hatches, lock the cabin door, remove and stow
any removable electronic gear (fishfinders,
GPS, etc.) and personal gear (fishing poles,
etc.) normally left aboard your boat.
8. S
L
EACOCK
UBRICATION
•
With boat out of water, remove the hose from
top of the seacock.
•
Put seacock handle in closed position.
•
Add a few drops of lubricating oil inside.
•
Work handle back and forth a few times. Add
oil as needed.
•
Replace hose and tighten clamp.
•
Add a few drops of oil to the handle pivot point.
8.8
I
EQUIRED
NSPECTION
M
AINTENANCE
9. E
Follow the oil exchange instructions found in Section
4 - Bilge and Underwater Equipment , page 4.6.
In each case follow the intervals and oil change
instructions provided by the engine manufacturer.
REFER TO THE ENGINE OWNER'S MANUAL
FOR
INFORMATION.
https://www.boat-manuals.com/
, S
ERVICE AND
S
EACOCK
(F
. 8.8.1)
IG
HOSE
HOSE CLAMPS
SEACOCK BODY
O
C
NGINE
IL
HANGE
INSTRUCTIONS
58 Sedan Bridge (585 Sedan Bridge)
SEACOCK
HANDLE
OPEN
PIVOT POINT
S
YSTEM
AND WARRANTY
Advertisement
Table of Contents
