Fitting Out After Storage; Fuel System; Battery(Ies); Miscellaneous - Sea Ray 260 Sundancer Owner's Manual

Hide thumbs Also See for 260 Sundancer:
Table of Contents

Advertisement

S
8 • R
ECTION
D
IESEL
Fill fuel tank with diesel and recommended
amount of biocide, "Biobor
bacteria and fungi from contaminating diesel fuel
that contains some water.
Diesel fuel should also get a petroleum distillate
additive, such as "Stabil
This will absorb water in the fuel and prevent
freezing problems.
Run engine(s) for ten minutes to ensure that all
diesel fuel in injectors and fuel lines is treated.
DETAILED WINTERIZING, OPERATING INSTRUCTIONS
AND WARRANTY INFORMATION ARE PROVIDED BY
THE EQUIPMENT MANUFACTURER AND CAN BE
FOUND IN THE OWNER'S PACKET.
!
CAUTION
Do not overfill. Filling a tank until the fuel flows from
vents is dangerous. Allow room for expansion.
5. F
ITTING OUT AFTER
A. F
S
UEL
YSTEM
Check the entire fuel system for loose connections,
worn hoses, leaks, etc. and repair. This is a primary
safety precaution.
Check fuel lines for damage and make sure that
they do not come in contact with any moving parts.
B. B
(
)
ATTERY
IES
Before installing the batteries, clean the terminal
posts with a wire brush or steel wool and then attach
the cables. After the cable clamps are tightened,
smear the post and clamps with vaseline or grease
to exclude air and acid. Do not apply grease before
260 Sundancer
(275 Sundancer
®
I
EQUIRED
M
AINTENANCE
", which prevents
®
" or Racor
RX100".
®
®
S
TORAGE
)
®
, S
NSPECTION
attaching and tightening the terminal clamps.
Examine all wiring.
C. M
ISCELLANEOUS
Check all thru-hull fittings for unobstructed
water passage. Be alert for any deteriorated
hoses and/or fittings below the water line which
might fail in service and admit water.
Test the navigation lights.
Check all wiring for loose connections.
Check all switches and equipment for proper
operation.
Check bilge blowers for proper operation. Turn
ON blowers and place hand over hull blower
vent to make sure air is coming from vent.
Anchor lines and gear should be inspected
and replaced if necessary.
Make sure the hull drain plug is in place and
tight.
Clean bilge thoroughly if it was not done at
lay-up.
Check all engine fluid levels.
Check fuel lines for damage and/or leaks. Make
sure that they do not come into contact with
moving parts.
6. S
C
ECURITY
ONSIDERATIONS
Be conscious of the security of your boat.
Always remove the keys from the ignition, lock
hatches, lock the cabin door, remove and stow
any removable electronic gear (fish finders,
GPS, etc.) and personal gear (fishing poles,
etc.) normally left aboard your boat.
ERVICE AND
8.7

Advertisement

Table of Contents
loading

Table of Contents