Changinga Blown Bulb; Ac Low Voltage Lighting - Sea Ray 58 Sedan Bridge Owner's Manual

S
!
The filament bulbs used in all Xelogen-cycle lamps
generate intense heat. To avoid the possibility of
fire, do not use lamp at close range to materials
that are combustible or affected by heat or drying.
Xelogen-cycle bulbs are pressurized and could
shatter if scratched or damaged. Glass Xelogen-
cycle bulbs should be protected against contact
with liquids when operating.
panel as well as the AC distribution panel located in
the port salon.
A. C A B
HANGING LOWN
Use appropriate protection, such as a clean cloth
or gloves when handling or disposing of all Xelogen-
cycle bulbs. Wear eye protection. Turn power off
when installing or before removing lamp. Allow lamp
to cool before removal. Remove grease or
fingerprints from new Xelogen bulbs with a grease-
free solvent before use.
1. Grab light fixture housing
and pull gently from ceiling
or wall.
NOTE:Take care when pulling the housing as it is
spring loaded in the socket and the clips will snap
quickly downward when released from the ceiling
or wal
2. Grab the fixture containing
the bulb and twist counter
clockwise.
6.18
6 • E
ECTION
CAUTION
B
ULB
https://www.boat-manuals.com/
S
LECTRICAL
3. Pull the fixture out of the
housing and replace the
bulb with a bulb of equal
wattage. NOTE: The glass
face plate in the housing is
very fragile. Be careful that
it remains in place and
does not fall out, as it will
break easily.
4. To replace the housing,
reverse the previous
directions. Grab the clips
and hold them upwards
until the housing is placed
into its receptacle in the
wall or ceiling. Push gently
to seat the light housing
securely.
B. AC L V
OW OLTAGE
Some overhead lighting in the V-berth, guest
stateroom, master stateroom and the port and
starboard salon are powered by the generator or
the shore power system. Transformers located
L V L
OW OLTAGE IGHTING
(F . 6.18.1)
IG
58 Sedan Bridge (585 Sedan Bridge)
YSTEM
L
IGHTING
T
RANSFORMERS