Precommissioning - Kärcher KM 85/50 R Bp Manual

– Operating hours
– Battery charge
– Next service
– Software version
Ignition key
3
– Remove the ignition key: Every time you leave the device
– Position 0: Device is off
– Position 1: Device is ready for operation
Wet sweeping flap
4
– Open for sweeping wet or damp surfaces
Selector switch for direction of travel
5
– Push switch back: reverse
– Push switch forward: forwards
Horn
6
– Press switch to warn of danger
Seat adjuster
7
– Pull lever to adjust seat horizontally
Steering wheel height adjustment
8
– Open the nut to adjust the height
Waste container
Transport rolls
1
Waste container
2
Waste container lock
3
Storage area
4
– Max. load 20 kg
Fastening lugs
5

Precommissioning

Opening / closing the cover
CAUTION
Risk of crushing fingers
Only use the recessed grip provided to open and close the cover.
Note
It is necessary to open the cover:
1 to connect / install the batteries.
2 to charge the batteries.
3 to clean / replace the dust filter.
4 to replace the roller brush.
Recessed grip
1
Cover
2
Cover in rest position
3
Closing the cover
4
1. To open the cover, take hold of the recessed grip at the front
and pivot it backwards.
2. The cover is held at the end of the elongated hole in the rest
position by the locking rod.
3. To close the cover, push the locking rod upwards so that it
does not engage in place, then slowly pivot the cover down.
DANGER
Risk of accidents when unloading the device
Use a suitable ramp when unloading the device.
Do not use a forklift to unload / load the device.
Be aware of the weight of the device when unloading / loading.
DANGER
Risk of overturning in case of improper handling
Do not drive onto or from the ramp at an angle.
Do not turn on the ramp.
Drive at an adapted speed.
1. Connect the battery and charge it as necessary (see chapter
"Battery").
2. When delivered on a pallet, the parking brake of the device is
disabled. The neutral lever is in the OFF position (see chapter
"Pushing / driving the device").
a When the parking brake is deactivated, the device can be
pushed off the pallet. To drive, pull the neutral lever up to the
ON position.
b If the device is to be moved from the pallet, pull the neutral
lever up to the ON position.
If the device is delivered on a pallet, build a ramp to drive the de-
vice down using the boards included.
1 Cut the plastic packing strips and remove the film.
2 Connect the battery (see chapter "Batteries / chargers").
3 Remove the tightening strap fasteners.
4 Unscrew 4 marked flooring boards fastened with screws to the
pallet.
5 Position these 4 boards on the edge of the pallet; align the
boards such that they are beneath the wheels when driving the
device off the pallet.
6 Place wooden blocks and a board and secure them using
screws beneath the flooring boards to support them (see illus-
tration).
7 Drive or push the device off the pallet using the ramp created
(see chapter "Precommissioning | Pushing / driving the de-
vice").
English
Unloading instructions
19