Connecting To The Neutral Ct - GE Intellix BMT 330 Installation Manual

Bushing monitoring and partial discharge detection for transformers

Hide thumbs Also See for Intellix BMT 330:

Table of Contents

Table C-5: Connecting to the grounding switch

Steps

1. The central white wire must be

connected to the core connector.

2. The braid shield must be connected to

the shield connector.

3. Repeat these steps for all input phases

for the Bushing Adaptors and the

Neutral CT(s).

C.6

Connecting to the Neutral CT

Note:

At the Neutral CT end, the coaxial cable does not require terminals.

Table C-6: Connecting to the Neutral CT

Steps

1. Remove approximately 25 mm (1 in.)

of the outer jacket from the coaxial

cable (taking care not to cut the

metallic braid).

2. Un-strand the metallic braid shield

and twist it together.

3. Select one piece of heat shrink tubing

in., about 15 mm (5/8 in.) long.

MA-017 – BMT 330 Installation Manual – Rev 3.3

Visual

4-Mar-22

Page 47 of 69

Table of Contents

Do you have a question about the Intellix BMT 330 and is the answer not in the manual?