Temperature Control Setting - Immergas TRIO PACK HYBRID 4 Instructions And Warnings

1.20 TEMPERATURE CONTROL SETTING.

By setting the parameters in the menus
Zones/Configuration
it is possible to automatically adjust the flow temperature of each
zone according to the outdoor temperature.
Zone flow temperature in central heating mode
and enabled external probe modulation
A
B
C
Zone flow temperature in cooling mode
and enabled external probe modulation
A
B
C
Key (Fig. 22, 23, 24 and 25)
A - Maximum flow set
B - Minimum flow set
C - External minimum temperature
D - External maximum temperature
E - Central heating flow temp offset
F - Central heating / C.H. flow set
G - Cooling flow temperature offset
H - Cooling flow set
TE - Outside temperature
TM - Flow temperature
28
E
D
G
D
This can be done by enabling the external probe modulation in
the menu
Zones/Enablings.
The curves (Fig. 22, 23, 24 and 25) show the default settings in
the various operating modes available both with external probe
and without.
Zone flow temperature in central heating mode
and absent external probe modulation
22
Zone flow temperature in cooling mode
and absent external probe modulation
23
F
H
24
25