42
43
44
EXPANSION BOARD FOR ZONE MANAGEMENT
76
AUDAX TOP ErP and Integrated System
ZONE REMOTE CONTROL
ROOM TEMPERATURE/HUMIDITY SENSOR
It is an electronic device equipped with a back-lit display to
control and adjust the room's temperature and humidity. Con-
nection to the system Manager is on the same BUS connection
as AUDAX TOP ErP and temperature-humidity probes.
It programs the relative room heat adjustment.
It can be applied to the wall using the supplied screws and plugs.
The kit must be powered at 230 Vac.
• OPTIONAL
It is a room temperature and humidity probe, to be applied to
the wall.
Differently to the zone remote control kit, in this case, the set-
tings of all room parameters take place on the System Manager.
The kit must be connected directly to the expansion board for
zone management.
The kit must be powered at 24 Vac.
• OPTIONAL
This component must be powered at 24 Vac and is mainly used
for system zone management; in particular n°1 expansion kit
must be used for each zone. The expansion kit manages pump,
mixing valve and the dehumidifier of the same zone, acquiring
the room request (temperature and humidity) for a determined
zone. The following can be connected to this kit:
- the room temperature - humidity sensor;
- an ON-OFF type request contact.
Installation takes place on a DIN guide for electric components
from control board. This board is envisioned as per standard
in the 2 kits for zone systems (see the following page).
• OPTIONAL
code 3.023364
code 3.021524
code 3.021547