Immergas TRIO PACK HYBRID 4 Instructions And Warnings page 8

Installation Standards.
This indoor unit, if installed in an external wall, requires
the use of the special "Solar Container" to be fixed with
the support brackets supplied together with the package
itself. In combination with the "Solar Container" it was not de-
signed to be installed on plinths or floors. It was not designed
to be installed without the special recessed frame.
The installation of the "Solar Contain-
er" in the wall must ensure a stable and
efficient support of the UI TPE. The UI
TPE ensures appropriate support only if in-
stalled correctly (according to the rules of good
practice), following the instructions on its in-
structions leaflet. The "Solar Container" for UI
TPE is not a supporting structure and cannot
replace the piece of wall removed. It is there-
fore necessary to check its correct positioning
inside the wall. For safety reasons against any
leaks it is necessary to plaster the pack housing
in the brick wall. This pack is used to heat water
to below boiling temperature in atmospheric
pressure. It must be connected to a central
heating system and domestic hot water circuit
suited to its performance and capacity.
If it is planned to be installed with the use of the special
"Domus Container", the indoor unit must be installed
in an environment in which the temperature cannot
fall below 0°C.
Do not expose the indoor unit to atmospheric agents.
Do not install in places/rooms that
constitute public areas of apartment
buildings, internal stairways or other
escape routes (e.g. floor landings, entrance
halls, etc.).
To prevent electrocution, fire or injury,
always switch off the unit, disable the
protective switch and, if smoke escapes
or if the unit is extremely noisy, contact an
Authorised After-Sales Technical Assistance
Centre.
Do not install in places where there is
the risk of combustible gas escaping.
Do not install near sources of heat.
8
Pay attention not to generate sparks as
follows:
- Do not remove the fuses while the
unit is on.
- Do not unplug the unit while it is on.
It is recommended to install the outlet high
up. Lay the cables in such a way that they do
not get tangled.
This indoor unit is used to heat water to below boiling
temperature in atmospheric pressure.
They must be connected to a central heating system and
domestic hot water circuit suited to their performance
and capacity.
The appliance is built to also operate in
cooling mode.
If cold water production, during sum-
mer, could interfere and damage the central
heating only systems, necessary precautions
must be taken to prevent that an unintentional
production of cold water enters the heating
only system.
Failure to comply with the above im-
plies personal responsibility and inval-
idates the warranty.
"Anti-legionella" thermal treatment of the accumulation stor-
age tank unit.
The anti-legionella function is programmed directly
on the panel.
During this phase, the temperature of the water inside the tank
exceeds 60°C with the subsequent risk of burns.
Keep this domestic hot water treatment under control (and inform
the users) to prevent unforeseeable damage to people, animals,
things.
If required install a thermostatic valve on the domestic hot water
outlet to prevent scalding.