Step 2 – Install Rack to Feet ..........................5 Before You Begin Read all instructions prior to assembling or installing any Kargo Master product. Always locate your installation locations prior to performing any work. ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE.
Instructions – 4081SF DO NOT EXCEED MANUFACTURERS WEIGHT CAPACITY FOR ROOF Step 1 – Install Feet to Factory Rails Measure the bow center to bow center distance on rack being installed. Standard bow-to-bow distances are 71-1/2” or 96”. Slide a rail slider into factory rail on one side of vehicle.
Page 5
Instructions – 4081SF Position feet center-to-center at the distance measured previously. o Standard bow-to-bow distances are 71-1/2” or 96”. o Rear foot should be about 12” to 14” inches from the rear of vehicle for rack handle clearance. Loosely tighten hardware.
Instructions – 4081SF Step 2 – Install Rack to Feet Set rack on feet. Center rack to vehicle. Center rack to vehicle. Using 3/8” x 1” hex head bolts, 3/8” lock washers, and 3/8” flat washers, install rack bows to feet.