Access Panel
Before accessing the internal components of the HP Workstation xw4200, the access panel must be
removed.
To remove the panel:
WARNING!
Ensure that the workstation is turned off and that the power cord is disconnected from the
electrical outlet before removing the workstation access panel.
1
Disconnect power from the system
lock
(page
75), and disconnect the universal clamp lock
2
Lay the unit in the desktop position as shown in the following illustration.
3
Pull up and out on the cover latch
then lift up.
To replace the access panel, lay it flat on the unit about one inch from the bezel. The hooks should fall
into the recesses. Then slide the cover towards the bezel until it snaps into place.
(page
73) and, if necessary, unlock the security lock and cable
1
and at the same time slide the cover
2
1
REMOVAL AND REPLACEMENT OF COMPONENTS 77
(page
76).
2
away from the bezel and