HP xw4200 Service And Technical Reference Manual page 103

4 After pulling the drive 1
5 Verify the jumper settings of the new drive are set correctly.
6 To install a drive, first remove the front bezel
guide screws 1 into the drive. Align the screws with the slots on the drive, and slide the drive
the unit until it snaps into place.
NOTE All optical drives may not fit in the bottom optical bay due to interference with the system board.
Check the fit of your drive before installing it into the bay.
7 Connect the drive, power, and audio cables.
NOTE The audio cable is included with Linux-based systems only. Windows-based systems do not
require the audio cable.
out, remove the four guide screws
1
(page
2
2 from the drive.
2
2
80) and bezel blanks (page
1
1
REMOVAL AND REPLACEMENT OF COMPONENTS 103
80). Insert the four
2 into