Connecting 100-Pin 0.5-Mm-Pitch Foot Pattern (Part 1) - Renesas M30830T-RPD-E User Manual

(5) Connecting 100-pin 0.5-mm-pitch Foot Pattern (Part 1)

Figure 3.16 shows how to connect the emulation pod probe to the 100-pin 0.5-mm-pitch foot pattern
on the target system with the M3T-100LCC-QSD (not included), and here following is its procedure.
For details on the M3T-100LCC-QSD, refer to its user's manual.
(1) Attach the M3T-100LCC-QSD to the target system.
For details on how to attach the M3T-100LCC-QSD to the target system, refer to its user's
manual.
(2) Attach the M30800T-PTC to the FLX160-PRB.
(3) Attach the M30800T-PTC to the M3T-100LCC-QSD.
Figure 3.16 Connecting the emulation pod probe and 100-pin 0.5-mm-pitch foot pattern (part 1)
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The small connectors of the M30800T-PTC are guaranteed for only 50 insertion/
removal iterations.
CAUTION
( 41 / 74 )