Connecting 100-Pin 0.65-Mm-Pitch Foot Pattern (Part 2) - Renesas M30830T-RPD-E User Manual

(3) Connecting 100-pin 0.65-mm-pitch Foot Pattern (Part 2)

Figure 3.14 shows how to connect the emulation pod probe to the 100-pin 0.65-mm-pitch foot pattern
on the target system with the M3T-DIRECT100S (not included), and here following is its procedure.
For details on the M3T-100LCC-DMS and M3T-DIRECT100S, refer to each user's manual.
(1) Attach the M3T-DIRECT100S to the target system.
(2) Attach the M3T-100LCC-DMS to the M3T-DIRECT100S.
(3) Attach the M30800T-PTC to the FLX160-PRB.
(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.
Figure 3.14 Connecting the emulation pod probe and 100-pin 0.65-mm-pitch foot pattern (part 2)
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The small connectors of the M3T-100LCC-DMS and M3T-DIRECT100S are
guaranteed for only 20 insertion/removal iterations.
• The small connectors of the M30800T-PTC are guaranteed for only 50 insertion/
removal iterations.
CAUTION
( 39 / 74 )