Renesas M30830T-RPD-E User Manual page 28

Table 3.3 Switch settings of the M30830T-RPD-E (3/4)
Signal Switch
AV /AV SW7
CC SS
Note on Switch Setting:
• Switch settings of RDY*/HOLD*, CNVss, BYTE and AV
enable debugging without connecting to the target system. When using the emulator
debugger in connection with the target system, set SW4 and SW7 to the OPEN
positions and SW5 and SW6 to the center positions.
Setting
SW7
AVCC
Connects the V
OPEN
of the MCU, respectively.
Factory-setting
Be sure to set this when using the emulation board
without the target system.
VCC
SW7
AVCC
OPEN
Connects pin AV
system.
VCC
IMPORTANT
( 28 / 74 )
Description
and V to pins AV and AV
CC SS CC
/AV of the MCU to the target
CC SS
/AV are provided to
CC SS
SS