Chapter 3. Setting Up
To use this emulation pod with your application system, it is necessary to make settings as follows.
Set the following after removing the upper cover.
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
Figure 3.1 Removing the upper cover
When Removing the Upper Cover:
• Change the oscillation frequency.
• Set pins X
and X
CIN
COUT
• Set the signals such as HOLD/RDY to control the external device.
• Install the A-D conversion bypass capacitor.
(1) Remove the four screws of both sides of this product and lift off the upper cover (see Figure 3.1).
(2) Set the jumper switches.
(3) Replace the upper cover and secure the four screws.
• Always shut OFF power when removing the upper cover or setting the switches.
• Do not touch the connector pins of the emulator main unit and the target MCU
connector pins. Static electricity may damage the internal circuits.
for the target system.
CAUTION
( 24 / 74 )