Renesas M30830T-RPD-E User Manual page 27

Table 3.2 Switch settings of the M30830T-RPD-E (2/4)
Signal Switch
RDY*/
SW4
HOLD*
CNV SW5
SS
BYTE SW6
Setting
SW4
RDY/HOLD
OPEN Pulls up pins RDY* and HOLD* of the MCU with a
Factory-setting resistance of 33 kΩ. Be sure to set this when using
the emulation pod without the target system.
H
SW4
RDY/HOLD
OPEN
Connects pins RDY* and HOLD* of the MCU to the
target system.
H
SW5
Pulls down pin CNV
CNVss
H
(when the target system is unconnected in single-
chip mode or memory expansion mode).
Factory-setting
Be sure to set this when using the emulation pod
without the target system.
L
SW5
CNVss
H
Connects pin CNV
L
SW5
Pulls up pin CNV
CNVss
H (when the target system is unconnected in
microprocessor mode).
Be sure to set this when using the emulation pod
without the target system.
L
SW6
Pulls down pin BYTE with a resistance of 33 kΩ
BYTE
H
(when the target system is unconnected in 16-bit
bus mode).
Factory-setting
Be sure to set this when using the emulation pod
without the target system.
L
SW6
BYTE
H
Connects pin BYTE to the target system.
L
SW6
Pulls up pin BYTE with a resistance of 33 kΩ
BYTE
H (when the target system is unconnected in 8-bit
bus mode).
Be sure to set this when using the emulation pod
without the target system.
L
( 27 / 74 )
Description
with a resistance of 33 kΩ
SS
to the target system.
SS
with a resistance of 33 kΩ
SS