System Configuration Commands - Pacific Power Source AFX Series Operation Manual

Query Format
Description
Returned Data Format
Query Example
8.9.2

System Configuration Commands

Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2016 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
SYSTem:TIME:SOURce?
Queries source of date and time information.
<cr>
SYST:TIME:SOUR?
NTP
Note: NTP stands for "Network Time Protocol". A protocol built on top
of TCP/IP that assures accurate local timekeeping with reference to
radio, atomic or other clocks located on the Internet. This protocol is
capable of synchronizing distributed clocks within milliseconds over
long time periods. It is defined in STD 12, RFC 1119 (RFC = Request for
comment. RFCs are used by the Internet Engineering Task Force (IETF)
and other standards bodies.
SYSTem:MAXKVA?
Returns maximum available kVA output capability of the power source.
Example for 3150AFX model = 15.0000
<nr2>
SYST:MAXKVA?
15.000
SYSTem:MAXCURRent?
Returns maximum available RMS or DC output current capability of the
power source. Example for 3150AFX model = 41.6667.
<nr2>
SYST:MAXCURR?
41.6667
SYSTem:MAXVOLTage?
Returns maximum available RMS or DC voltage output capability of the
power source. Example for 3150AFX model = 300.
<nr1>
SYST:MAXVOLT?
300
SYSTem:COMPatible
Sets Pacific Power Source UPC controller compatibility mode. This
mode allows use of the power source with legacy software.
< 0 | DISABLE | 1 | UPC >
SYST:COMP UPC
SYSTem:COMPatible?
<b>
SYST:COMP?
1
AFX SERIES® OPERATION MANUAL
SECTION 8: REMOTE PROGRAMMING
Page 202 of 274