Lan Interface; System Interface Bus Connectors; Parallel Operation; Figure 5-22: Afx Series® Rear Panel Layout - Pacific Power Source AFX Series Operation Manual

5.17.5 LAN Interface

The LAN interface connector is installed on the rear panel. The MAC address of the unit can
be found near the LAN connector. When present, an "L" is appended to the models number,
e.g. 3150AFX-2L.
No special device drivers are required to use the LAN interface as it uses TCP/IP protocol but
the IP address needs to be configured to operate on the user's local area network or private
network.
MAC Address

5.17.6 System Interface Bus Connectors

SHOCK HAZARD: DO NOT remove safety covers from the two System Interface DVI Connectors.
RISQUE DE CHOC: NE PAS retirer les capots de sécurité des deux connecteurs d´interface DVI
The system interface bus is not user-accessible. It consists of two Digital Visual Interface
(DVI-I dual link) connectors that are covered by a protective cover. There are no user
accessible signals on the system interface bus. It is used for system configuration cabinet
systems only.
5.18

Parallel Operation

Two or more AFX units can be configured as a parallel system to create a high power
system. This requires at least one Master AFX unit and one or more Auxiliary units.

Entire Contents Copyright 2016 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Figure 5-22: AFX Series® Rear Panel Layout
WARNING
AVERTISSEMENT
AFX SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Page 67 of 274