Configuration Unit Settings - Pacific Power Source AFX Series Operation Manual

AFX SERIES® OPERATION MANUAL
SECTION 10: LAN INTERFACE

10.9.1 Configuration Unit Settings

Unit settings determine the mode of operation of the power source. This includes phase mode,
voltage range, output mode, update phase angle and ramp time for any output value changes
made.
Output enable at power on allows the unit to power up with the output enabled.
The Enable Current Overload setting allows short duration overloads up to 30% over the normal
continuous mode current limit set point.
The maximum adjustment limit for continuous self calibration mode and fault generation on
saturation can be set from this screen as well.
These can all be set from the CONFIGURATION -> UNIT SETTINGS screen shown below.

Entire Contents Copyright 2016 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 248 of 274