6.8
SYST – SYSTEM Screens
The System screens allow setting of secondary system level functions that are used less
often than the first four screens. This generally involves setting system level operation
modes and parameters to tailor the instruments operation to the user's specific
requirements and/operating environment. These include the following areas:
•
Remote Control Interfaces
•
System level settings, logs and firmware updates
•
Calibration
•
Parallel Operation
•
Options if any
Pressing the SYST key will display the first of two CONFIGURATION screens as shown below.
The More soft key will allow moving back and forth between the two main SYSTEM screens.
Selections on each screen are made by scrolling through the available entries using the
shuttle knob. Pressing the Enter soft key, ENTER key or shuttle will display the selected
highlighted entry screen.
Entire Contents Copyright
2016 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual
Figure 6-21: SYSTEM MAIN MENU 1
Figure 6-22: SYSTEM MAIN MENU 2
AFX SERIES® OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Page 111 of 274