Troubleshooting - DeLonghi ECAM45.76 Series Instructions For Use Manual

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot.
The coffee is weak or not creamy
enough.
The coffee is delivered too slowly or a
drop at a time.
Coffee does not come out of one or
both of the spouts.
The appliance does not come on
The infuser cannot be extracted
POSSIBLE CAUSE
The cups were not preheated.
The infuser (A15) has cooled down be-
cause 2/3 minutes have elapsed since
the last coffee was made.
A low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The spouts (A7) are blocked.
The power cord (C8) connector is not
inserted correctly.
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A20) is not turned on. Press the main switch (fig. 2).
The appliance has not been turned off
correctly.
25
SOLUTION
• Enable the cup warmer (A6), leave the
cups at least 20 minutes to warm up.
• Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
Before making the coffee, heat the infuser by
rinsing using the rinse function (page 10).
Set a higher coffee temperature in the menu
(page12).
Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (fig. 14). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see the section: "Adjusting the coffee
mill" on page 13).
Use pre-ground coffee for espresso machines.
Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
mill is in operation (fig. 14). Continue one click
at a time until coffee delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see the section: "Adjusting the coffee
mill" on page 13).
Clean the spouts with a toothpick (fig. 35, page
18).
Insert the connector as far as it will go in the
socket at the back of the appliance (A19- fig.
1).
Turn the appliance off by pressing the
ton (B1) (page 10).
but-