Displayed Messages - DeLonghi ECAM45.76 Series Instructions For Use Manual

DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A10) is full.
GROUND TOO FINE ADJUST
MILL
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
ADD PRE-GROUND COFFEE
DESCALE
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
POSSIBLE CAUSE
Insufficient water in the tank (A16).
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
been replaced (A10).
With the "pre-ground coffee" function selected,
pre-ground coffee has not been poured into the
funnel (A4).
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser has not been replaced after clea-
ning (A15).
SOLUTION
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
Empty the grounds container and drip tray
(A12), clean and replace (fig. 31). Important:
when removing the drip tray, the grounds
container (A10) MUST be emptied, even if it
contains few grounds. If this is not done, when
you make the next coffees, the grounds contai-
ner may fill up more than expected and clog the
machine. If the problem persists, make sure the
water tank (A16) is fully inserted, press the
button (B7) and deliver a little water from the
spout (C6).
Repeat coffee delivery and turn the grin-
ding adjustment dial (A5, fig. 14) one click
clockwise towards "7" while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
the section: "Adjusting the coffee mill" on page
13).
Insert the hot water spout (C6) in the appliance
and deliver a little water until the flow beco-
mes regular.
Remove the drip tray (A12) and insert the
grounds container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 18).
The descaling procedure described in the section
"Descaling" needs to be performed as soon as
possible (page 19).
Select a milder taste by pressing the
button (B2- fig. 11) or reduce the quantity of
pre-ground coffee.
Fill the beans container (fig. 15).
Empty the funnel with the help of a brush (C5)
as described in the section "Cleaning the pre-
ground coffee funnel" (page 18).
Insert the infuser as described in the para-
graph "Cleaning the infuser" (page 18).
23