CONTENTS Customising the “LONG coffee” quantity ....13 If the programme uses pre-ground coffee, the INTRODUCTION ..........7 appliance will prompt you to add a second level Symbols used in these instructions ......7 measure of coffee..........13 Letters in brackets ............7 MAKING CAPPUCCINO AND HOT MILK (NOT Troubleshooting and repairs ........7 FROTHED) ............
INTRODUCTION • Never touch the appliance with damp hands or feet. • Never touch the plug with damp hands. Thank you for choosing this automatic espresso and cappuccino • Make sure the socket used is freely accessible at all times, machine.
Designated use A18. Water tank A19. Water softener filter housing This appliance is designed and made to prepare coffee and heat A20. Water tank lid drinks. A21. Main switch This is a household appliance only. It is not intended to be used in: Description of the control panel •...
Do not place the appliance near taps or sinks. • When using the appliance for the first time, you need to • The appliance could be damaged if the water it contains make 4-5 cups of coffee or 4-5 cappuccinos before it starts freezes.
• release the main switch at the back of the appliance (fig. Please note! To enable this function, the time must already be set correctly. Important! Never press the main switch while the appliance is on. To enable auto-start, proceed as follows: 1.
1. Press the MENU/ESC button to enter the menu; Please note! 2. Press < or > (fig. 9) until “Default values” is displayed; • When in energy saving mode, a few seconds may elapse 3. Press the button; before the first coffee is delivered as the appliance must 4.
Customising the “my coffee” quantity Making coffee using coffee beans The appliance is set by default to automatically deliver 30 ml of Important! “MY COFFEE”. Do not use caramelised or candied coffee beans as they could To modify this quantity, proceed as follows: stick to the coffee mill and make it unusable.
MAKING CAPPUCCINO AND HOT MILK (NOT 2. Open the pre-ground coffee funnel lid. 3. Make sure the funnel is not blocked, then add one level FROTHED) measure of pre-ground coffee (fig. 17). Danger of burns! 4. Place a cup under the coffee spouts. During preparation, steam is given off.
2. Press the button (fig. 3). “HOT WATER” is displayed, Danger of burns! together with a progress bar which fills gradually as prepa- Stop steam delivery before removing the container with the ration proceeds. frothed milk to avoid burns caused by splashes of boiling milk. 4.
Even if not full, the empty grounds container message is displa- 3. Replace the filter (if present), fill the tank with fresh water yed 72 hours after the first coffee has been prepared. For the and replace the tank. 72 hours to be calculated correctly, the machine must never be turned off using the main switch.
Pour the descaler into the tank up to level A (corre- sponding to a 100 ml pack) marked on the back of the tank (fig. 36), then add water (1 litre) up to level B (fig. 36) and put the water tank back. Place an empty container with a minimum capacity 8.
Measuring water hardness 3. To activate the filter, run tap water through the hole in the filter as shown in the figure until water comes out of the 1. Remove the “TOTAL HARDNESS TEST” indicator paper from openings at the side for more than a minute (fig. 38). its pack (attached to the English instructions).
Replacing the filter • EMC Directive 2004/108/EC and subsequent amendments; • European Stand-by Regulation 1275/2008; When “REPLACE FILTER” is displayed, after two months (see date • Materials and accessories coming into contact with food indicator) or when the appliance has not been used for 3 weeks, conform to EC regulation 1935/2004.
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it cor- rectly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A12) is full. Empty the grounds container and drip tray, clean and replace (fig.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in the section “Cleaning”. If the message is still displayed after cleaning, contact a service centre. EMPTY CIRCUIT, FILL CIRCUIT The water circuit is empty Press to deliver water from the HOT WATER...
Steam delivery stops during use A safety device stops steam delivery Wait, and then enable the steam function after 3 minutes. again. The appliance does not come on. The power cable is not plugged in Plug the cable fully into the socket on the back properly.