DeLonghi ECAM45.36X Instructions For Use Manual
  1. Manuals
  2. Brands
  3. DeLonghi Manuals
  4. Coffee Maker
  5. ECAM45.36X
  6. Instructions for use manual

DeLonghi ECAM45.36X Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
De'Longhi Appliances via Seitz, 47 31100 Treviso Italia

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECAM45.36X and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for DeLonghi ECAM45.36X

Summary of Contents for DeLonghi ECAM45.36X

  • Page 1 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia...
  • Page 2 ECAM45.36X BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for use...
  • Page 3 page 6...

  • Page 7: Table Of Contents

    CONTENTS MAKING CAPPUCCINOS AND MILK BASED COFFEES ............13 INTRODUCTION ..........7 Filling and attaching the milk container ......13 Symbols used in these instructions ........7 Adjusting the amount of froth ........14 Letters in brackets ............7 Making milk based coffees automatically ...... 14 Troubleshooting and repairs ..........

  • Page 8: Introduction

    INTRODUCTION • Unplug directly from the plug only. Never pull the power cable as you could damage it. Thank you for choosing this automatic espresso and cappuccino • To disconnect the appliance completely, unplug it from the machine. mains socket. We hope you enjoy using your new appliance.

  • Page 9: Instruction For Use

    Description of the control panel This is a household appliance only. (page 2 - B ) It is not intended to be used in: A number of buttons on the panel have a double function. This is • staff kitchen areas in shops, offices and indicated in brackets in the description.

  • Page 10: Setting Up The Appliance

    Installing the appliance 3. “FILL TANK”: extract the water tank (fig. 4), open the lid (fig. 5), fill to the MAX line with fresh water (fig. 6); close Important! the lid again and then replace the tank. When you install the appliance, you should respect the fol- 4.

  • Page 11: Menu Settings

    1. Press the MENU/ESC button to enter the menu; Danger of burns! 2. Press < or > (fig. 9) until “Adjust time” is displayed; During rinsing, a little hot water flows from the coffee spouts. 3. Press the OK button (fig. 10): the hours flash; Avoid contact with splashes of water.

  • Page 12: Energy Saving

    Setting water hardness Proceed as follows: 1. Press the MENU/ESC button to enter the menu; For instructions on setting water hardness, see page 20. 2. Press < or > (fig. 9) until “Cup warmer” is displayed; 3. Press the OK button: “Enable?” or “Disable?” will be Setting the language displayed To modify the language of the display, proceed as follows:...

  • Page 13: Making Coffee

    5. Press the MENU/ESC button twice to exit the menu. Please note! The grinding adjustment dial must only be turned when the MAKING COFFEE coffee mill is in operation. Selecting the coffee taste If the coffee is delivered too slowly or The appliance is set by default to make coffee with a standard not at all, turn one click clockwise to- taste.

  • Page 14: Making Coffee Using Pre-Ground Coffee

    Press OK”. Add one level measure of pre-ground coffee and press Please note! • Various alarm messages could be displayed while using Coffee delivery resumes and the progress bar gradually fills as the machine (FILL TANK, EMPTY GROUNDS CONTAINER, preparation progresses. etc.).

  • Page 15: Adjusting The Amount Of Froth

    6. Attach the milk container to the connection nozzle and 4. Press < or > until the required drink is displayed (MILK, push as far as it will go (fig. 23). The machine emits a beep FLAT WHITE, ESPRESSO MACCHIATO or MY MILK). 5.

  • Page 16: Programming The Quantity Of Coffee And Milk In The Cup

    Programming the quantity of coffee and milk Please note! in the cup for the CAPPUCCINO, CAFFELATTE and If “Energy saving” mode is active, you may have to wait a few MACCHIATO buttons seconds before the hot water or steam is delivered. The appliance is set by default to automatically deliver standard quantities.

  • Page 17: Cleaning

    • To avoid milk with poor froth or large bubbles, always clean To clean (with the machine on): the spout as described in the following section. • Extract the drip tray (fig. 30), empty and clean. Cleaning the spout after use •...

  • Page 18: Cleaning The Pre-Ground Coffee Funnel

    3. Replace the filter (if present), fill the tank with fresh water Clean the infuser without using washing up liquid as it and replace the tank. could be damaged. 6. Use the brush (D2) to remove any coffee residues left in the Cleaning the coffee spouts infuser housing, visible through the infuser door.

  • Page 19: Cleaning The Hot Water/Steam Connection Nozzle

    to the procedure to follow in the event of contact with the skin and eyes. • You should use De’Longhi descaler only. Using unsuitable descaler and/or performing descaling incorrectly may re- sult in faults not covered by the manufacturer’s guarantee. 1.

  • Page 20: Setting Water Hardness

    WATER SOFTENER FILTER 11. Empty the container used to collect the descaler solution and replace it empty under the hot water spout. Certain models are fitted with a water softener filter. If this is not 12. Press the OK button to start rinsing. Hot water flows out the case with your model, you are recommended to purchase of the spout and the message “RINSING, Please wait”...

  • Page 21: Replacing The Filter

    Removing the filter If you want to use the appliance without the filter, you must remove it and notify the appliance of its removal. Proceed as follows: 1. Extract the tank and exhausted filter; 2. Press the MENU/ESC button to enter the menu; 3.

  • Page 22: Displayed Messages

    DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it cor- rectly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A10) is full. Empty the grounds container and drip tray, clean and replace (fig.

  • Page 23: Troubleshooting

    GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in the section “Cleaning”. If the message is still displayed after cleaning, contact a service centre. EMPTY CIRCUIT, FILL CIRCUIT The water circuit is empty Press OK and deliver water from the spout Water delivery (D5), until it flows out normally.
  • Page 24 Coffee does not come out of one of the The spouts are blocked. Clean the spouts with a toothpick (fig. 34). spouts. The appliance does not come on. The power cable is not plugged in Plug the cable fully into the socket on the back properly.
  • Page 25 ELECTRICAL CONNECTION (UK ONLY) Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the proce- dure outlined below.

Table of Contents