Subscribe to Our Youtube Channel
Related Manuals for DeLonghi ELLETA EXPLORE ECAM45.5Y Series
Summary of Contents for DeLonghi ELLETA EXPLORE ECAM45.5Y Series
- Page 1 ECAM45X.5Y - 45X.7Y BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for Use Instructions videos available at: http://eletta-explore.delonghi.com...
- Page 3 Explorer 1 Espresso Cappuccino Over ice Decalci cante per macchine da ca è Descaler for co ee machines Détartrant pour machines à café Entkalker für Ka eemaschinen De’Longhi Appliances s.r.l. Via L. Seitz, 47 31100 Treviso - ITALY Tel. +39 0422 4131 5413218631/04.15 Cold E5 E7...
-
Page 4: Table Of Contents
CONTENTS 9. MAKING MILK BEVERAGES U....13 9.1 Preparing the milk carafes (E and F) ....13 1. INTRODUCTION ..........5 9.2 Which milk to use? ........13 1.1 Letters in brackets .........5 9.3 Filling and attaching the milk carafes ..13 1.2 Troubleshooting and repairs ......5 9.4 Adjusting the amount of froth .....14 1.3 Download the App! ........5 9.5 Making milk beverages .......14... -
Page 5: Introduction
(see “6.3 Connectivity • Descaling required light (certain models only)”). • Check compatible devices on “compatibledevices.delonghi. • Filter exhausted light com”. C5. Bean Adapt Technology (enable from App): see ““8.5 Bean Adapt Technology & Espresso SOUL” (*certain models only) -
Page 6: Description Of The Accessories (D)
C6. Customisable profiles (see “14. Selecting your personal • You should customise water hardness as soon as possible following the instructions in section “17. Setting water profile”) hardness”. 2.4 Description of the accessories (D) (*varies 1. Connect the appliance to the mains supply (fig. 1). according to model) Accessories in the Starter pack: D1. -
Page 7: Turning The Appliance On U
capacity of 200 ml under the coffee spouts (A7) and hot water spout (fig. 6); 2. When at temperature, the appliance performs a rinse cycle delivering hot water from the coffee spouts(A7); as well as 7. Press “OK” to fill the water circuit. The appliance delivers heating the boiler, this also heats the internal circuits by water from the hot water spout (fig. -
Page 8: Descaling
6.2 Descaling Please note: • After carrying out the above procedure, we recommend For instructions on descaling, see section “16. Descaling”. making at least 3 coffees before adjusting again. If the 6.3 Connectivity (certain models only) coffee is still not brewed correctly, repeat the procedure. Use this function to enable or disable connectivity. -
Page 9: Set Auto-Off
5. Customise as you wish, then press “Save” to confirm. 6.13 Drain water 6. Press “<” to save the new selection and go back to the To avoid the water in the circuit freezing if the appliance is to be homepage (C). -
Page 10: Statistics
The next time the appliance is turned on, follow the instructions in Cold section “3. Setting up the appliance”. ✓ ✓ 6.14 Statistics Milk This displays statistics relating to the machine. To view the sta- ✕ ✓ Tea function tistics, proceed as follows: 1. -
Page 11: Customising The Beverages
• Depending on the previous selection, before delivery, • Select whether to make an “Iced” or “Extra Iced” bever- the appliance suggests the quantity of ice cubes. Add age, then press “Next”; the quantity of ice cubes indicated to the glass (fig. 14), •... -
Page 12: Bean Adapt Technology & Espresso Soul
5. The appliance starts making the beverage and a descrip- • increase the coffee temperature (section “6.5 Coffee temperature”). tion of each individual phase (grinding, brewing coffee) appears on the display. 8.8 Coffee pot At the end of preparation, the appliance is ready to make the Based on espresso coffee, this beverage is light and balanced, next beverage. -
Page 13: Cleaning The Coffee Pot
prepared and a description of each individual phase (grind- ing, brewing coffee) appears on the display. Plant-based beverages Please note: “Cancel” or Stop”: press to stop preparation completely and go ✓ ✓ back to the homepage. ✓ ✓ Almond 7. When delivery has ended, press “Save” to save the new set- tings, or “Cancel”... -
Page 14: Adjusting The Amount Of Froth
9.4 Adjusting the amount of froth 4. Turn the dial back to one of the froth selections; Turn the froth adjustment dial (E3) or (F3) to adjust the amount If you want to make a number of beverages in succession: of froth on the milk delivered while making milk beverages. -
Page 15: Making Hot Tea
10.2 Making hot tea Optional accessory in certain models: 1. On the homepage (C), press the image corresponding to Travel mug tea (C1); (capacity 473 ml/160 mm H) 2. Adjust the quantity and temperature; 3. Press “Brew”. Preparation begins and stops automatically. Type: DLSC073 Please note: EAN: 8004399024083... -
Page 16: Cleaning The Travel Mug After Use
• You should only use the travel mug for the beverages pres- 8. If you are satisfied with the result in the cup, press “Save” ent on the homepage. to save the settings, or “Cancel” to retain the previous • To use a travel mug other than the one supplied, make sure parameters. -
Page 17: Cleaning U
15. CLEANING U has been prepared. For the 72 hours to be calculated correctly, the machine must never be disconnected from the mains power 15.1 Cleaning the machine supply. The following parts of the machine must be cleaned regularly: Important! Danger of scalding the appliance’s internal circuit;... -
Page 18: Cleaning The Inside Of The Machine
rests on or the surrounding area. To remove the drip tray, pro- ceed as follows: 1. Remove the drip tray and coffee grounds container (A10) (fig. 28); 2. Check the red condensate tray (A12) and empty if full; 3. Remove the cup tray (A13) and drip tray grille (A14), then empty the drip tray and grounds container and wash all components;... -
Page 19: Cleaning The Milk Carafes (E) And (F)
4. Press the two coloured release buttons inwards and at the same time pull the brewing unit outwards (fig. 33); 5. Soak the brewing unit in water for about 5 minutes, then rinse under the tap; Important! RINSE WITH WATER ONLY NO DETERGENTS - NO DISHWASHER 6. -
Page 20: Descaling U
6. Remove and empty the drip tray (A15) and coffee grounds container (A10) (fig. 10), then put both back in the appli- ance and press “Next”; 7. Remove the water tank (A22), lift the lid (A21) and (if in- serted) remove the filter (D4). Empty the tank completely. 8. -
Page 21: Setting Water Hardness
17.2 Setting water hardness 12. Place the container used to collect the descaler solution empty under the spouts and press “Next” to start rinsing; 1. Press the settings menu icon (C3) on the homepage (C); 2. Scroll the pages and select “Water hardness”; 13. -
Page 22: Replacing Or Removing The Filter
Please note: 6. To replace the filter, press “Next” and follow the operations The filter lasts about two months if the appliance is used normally. described in the previous section from point (4). If the machine is left unused with the filter installed, it will last a Please note: maximum of 3 weeks. -
Page 23: Displayed Messages
20. DISPLAYED MESSAGES DISPLAYED MESSAGE MEANING SOLUTION Please fill the tank with fresh Insufficient water in the tank (A22). Extract the tank, fill with fresh water to above water up to MAX level. Be sure to Level 1 and put back in the appliance. fill above Level 1 I don’t have enough water for your beverage. - Page 24 DISPLAYED MESSAGE MEANING SOLUTION The new settings have not been While customising the beverages (see section “13. Press “X” to go back to the homepage (C) to view the saved “My” function (“Hot” beverages only)”), prepara- alarm causing the interruption. Follow the instruc- tion has been deliberately interrupted by pressing tions corresponding to the alarm displayed (see “X”...
- Page 25 DISPLAYED MESSAGE MEANING SOLUTION Water circuit empty. Press OK to The water circuit is empty Press “OK” to fill the circuit. Delivery stops au- tomatically. It is normal for there to be start filling process water in the drip tray (A15) afte3r filling. If the problem persists, make sure the water tank (A22)
-
Page 26: Troubleshooting
21. TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact customer services. PROBLEM POSSIBLE CAUSE SOLUTION The appliance does not come on It is not plugged into the mains socket. Plug into the mains socket (fig. - Page 27 PROBLEM POSSIBLE CAUSE SOLUTION The brewing unit (A6) cannot be The appliance has not been turned off Turn the appliance off by pressing the extracted. correctly button (A9) (see section “5. Turning the appliance off”). At the end of descaling, the appliance During the two rinse cycles, the water Follow the instructions displayed by the ap- requests a third rinse.
- Page 28 PROBLEM POSSIBLE CAUSE SOLUTION Too little To Go beverage is prepared An unsuitable quantity has been selected Choose a larger quantity (Medio Grande Adjust the quantity in the mug so that the next beverage is prepared correctly The travel mug cannot be inserted in the The travel mug compartment flap (A17) Open the flap and/or raise the coffee appliance...
- Page 32 De’Longhi Appliances via Seitz, 47 31100 Treviso, Italy www.delonghi.com...
Need help?
Do you have a question about the ELLETA EXPLORE ECAM45.5Y Series and is the answer not in the manual?
Questions and answers