Ignition System Power Supply - Kalamazoo K42DB-1-NA Use And Care Manual

Ignition System Power Supply

The ignition system utilizes a hot surface electronic ignition system with an AC power supply.
Plugging in the Grill
A short, factory-supplied cord is connected to the grill's electronic control box inside the back of the
grill. Run a customer-supplied, single-plug, grounded, outdoor-rated extension cord into the grill
chassis through the opening in the floor pan that is protected by the rubber grommet, or directly
out the back of the grill. Connect the customer-supplied cord to the short, factory-supplied cord. For
freestanding models, see
Be certain to connect the power to a GFI outlet. Check that the grill's central system is receiving
power by turning on the rotisserie motor (see page 36).
ELECTRICAL PRECAUTIONS:
1. To protect against electric shock, do not immerse cord or plugs in water or
other liquid;
2. Unplug from the outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts;
3. Do not operate any outdoor cooking gas appliance with a damaged cord,
plug, or after the appliance malfunctions or has been damaged in any
manner. Contact the manufacturer for repair;
4. Do not let the cord hang over the edge of a table or touch hot surfaces;
5. Do not use an outdoor cooking gas appliance for purposes other than
intended;
6. When connecting, first connect plug to the outdoor cooking gas appliance
then plug appliance into the outlet;
7. Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor
cooking gas appliance;
8. Never remove the grounding plug or use with an adapter of 2 prongs; and
9. Use only extension cords with a 3 prong grounding plug, rated for the power
of the equipment, and approved for outdoor use with a W-A marking.
+1.800.868.1699 41