Ignition System Power Supply - Kalamazoo K750GS Use And Care Manual

Ignition System Power Supply

The ignition system that lights the burners utilizes a hot surface electronic ignition system
with an AC power supply and a DC battery backup. The ignition system for cooktop burners
utilizes a 9 volt battery to power an electronic spark ignition system.
Plugging in the Grill
A short, factory-supplied cord is connected to the grill's electronic control box inside the main cabinet below
the grill (see Figure 12:S). Run a customer-supplied, single-plug, grounded, outdoor-rated extension cord into
the grill cabinet through the opening in the floor pan that is protected by the rubber grommet. Connect the
customer-supplied cord to the short, factory-supplied cord inside the cabinet.
Be certain to connect the power to a GFI outlet. Check that the grill's central system is receiving power by
turning on the control panel lights (see Figure 16:C) or rotisserie motor (see Figure 16:D). These two systems
rely on AC power only and do not utilize the battery backup system.
Changing the Ignition System Batteries
The starter burners can be lit using battery power. The battery backup system works automatically when AC
power is not available. The battery box is located inside the grill cabinet. The system uses 4 D-cell batteries.
Pop off the box cover (Figure 18:A) by depressing the tabs to replace the batteries.
The cooktop burners ignition is not connected to AC power. It runs on a single 9-volt battery. Screw off the cap
(see Figure 18:B) to replace the 9-volt battery.
FIGURE 18
B
A
26 KalamazooGourmet.com