Table of Contents
Advertisement
SuperBlade Server SBI-610P-1(C/T)2N User's Manual
Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier. Pull out the two
spring locking clasps and lift out the dummy drive.
Locking Clasps
Figure 2-5. Removing the Dummy Drive from a Carrier
2. Position the drive into the carrier with the connector end toward the rear of the carrier.
3. Tilt the drive to insert it onto the two posts on the right inside of the carrier.
4. Pull out the two locking clasps, seat the drive fully in the carrier, then push them back in
to secure the drive.
5. Insert the drive carrier into its bay, keeping the release button on the bottom.
6. When the carrier reaches the rear of the bay, push the handle in until it clicks into its
locked position
Post
Post
SB414_25HDD_TRAY_ASSY_REF
32
Advertisement
Table of Contents
