Table of Contents
Advertisement
1 PRODUCT ACCESSORIES
The product is packed together with service instructions. The heater is equipped with a safety valve as a
protective element. The valve is mounted on the cold water supply (see chapter 7- PLUMBING FIXTURE).
2 MESSAGE FOR CUSTOMERS
This electric heater is designed for preparation of hot water in households, cottages, and various welfare
facilities. It allows installation of only one hot water consumption point with no pressure connection. In case
of pressure connection, it is possible to connect more consumption points, but with limited use of parallel
consumption. Its advantage is that it heats up water by electric current in an unlimited all-day time range,
because of low accumulation it is not recommended to use the connection with the HDO control signal.
The time of the domestic water heating is about 9 and 18 minutes, depending on the volume.
3 TECHNICAL DESCRIPTION
The heater vessel is steel enamelled for pressure connection, the electric heating element is immersed.
The heater vessel consists of a magnesium anode that helps protect the heater vessel from corrosion.
The heater vessel is equipped with polyurethane insulation, all in a plastic top and upper cover. The electric
wiring is located in the lower (upper) part of the heater, under the removable heater cover. The water
temperature is pre-set to 55 °C (Optimum position). The cold water inlet is indicated with a blue circle, the hot
water outlet is indicated with a red circle.
TO/E 5.1, 10.1 UP - pressure heater with a capacity of 4.6 and 9.6 litres located above the consumption point
TO/E 5.1, 10.1 IN - pressure heater with a capacity of 4.6 and 9.6 litres located under the consumption point
The TO/E 5.1, 10.1 IN/UP heaters can also be used as non-pressure heaters.
- 5 -
Advertisement
Table of Contents
