Balanced Body The Contrology Cadillac Manual page 5

A)
B)
C)
Figure 3: A) Leg Springs (the longest springs)
B) Roll Back Bar Springs (have 2 dog clips attached)
C) Arm Springs (only 1 dog clip attached)
D)
E)
Figure 4: D) Trapeze Bar Spring
E) Push-through Bar Springs
11. Install the Trapeze bar Bar Springs to the Slider outside eye
bolts. The hooks of the springs should go on eye bolts and
dog clip attaches the Trapeze Bar Pad. Lastly attach the
Trapeze Bar Sling to the Trapeze Bar. See Figure 1.
12. Attaching the Push Through Bar Springs to the frame. The
spring with the (1) quick link is to be installed on the canopy
eye bolt for the Push through Bar. The (2) springs with the
Spring covers attach on the bottom frame eye bolts using
the long open hooks. See Figure 1. All dog clips will attach the
spring to the Push Through Bar.
13. Attach the Long Safety Chains to the outside eye bolts on the
top canopy head end. See Figure 1. Attach the short Safety
Chain to the middle eye bolt on the same end. The quick links
will be attached to the eye bolts in the canopy, see Figure 5.
Figure 5
14. Attach the loops to the end of the leg springs.
15. Attach handles to the arm springs.
16. Attach foot strap to foot end eye bolts on the frame. The
footstrap will have tubing over the clips. To install, slide the
tubing down to access the lever. Once installed move the
tubing back over the clip to prevent damaging the pad. To
see a video on this process, please visit the Support section at
Contrology.pilates.com. See Figure 1.
17. Install the Belly Strap over and around the upholstery pad.
18. If desired place the Large Kuna board up against the foot end
vertical tubes.
19. Provided leveling pads can be placed under the legs of your
device if needed. Use as needed.
TOY BOX VERSION
The base frame may have a factory installed hidden "Toy Box".
If your Base Frame has this feature, once the machine is in the
desired location and setup with the canopy, look under your top
frame rails to locate a plastic zip tie on the underside of your
Toybox. Using scissors or blade, cut this zip tie. This is installed
for shipping, and with it removed allows the lid to open.
Be sure to loosen the Belly Strap fully before trying to open the
lid or ensure it is not attached.
Make sure the PTB is out of the way or raise it up to the high
position and secure with the safety chain. Reposition or remove
any accessories or springs that may be in the way of the opening
Toy Box top.
There are (2) subtle recessed handles in the vinyl, on one side,
used for hand access points. Places your fingers into these
openings and lift the upholstery lid up. There are (2) gas shocks
that assist the lid up at a controlled speed. It will stop opening
on its own. This compartment can be used to store extra
loops, handles, springs, Kuna board, airplane board and other
accessories.
To close, make sure others are free and clear before closing,
push the lid down it will take a little force to get it started. Once
the lid is about 3" from the frame it will close on its own. Make
sure all fingers and clear when closing. Re-tighten the Belly Strap
as desired.
HOW TO ADJUST YOUR SLIDING TRAPEZE BAR
Position your hands on the outside of each slider. Place your
thumb and fore and/or middle fingers over the knobs; spin them
clockwise to lock threads into the tubes. This locks the Trapeze
Bar assembly into position so it does not slide. It is recommended
to always lock BOTH knobs for safety purposes. Spin the knobs
5