When printing on rolls, attach the Roll Holder to the roll.
Rolls have a two- or three-inch paper core. Use the correct attachment for the paper core. The printer comes
equipped with the 2-Inch Paper Core Attachment installed.
Items to Prepare
Set the roll on a table or other ﬂ at surface so that it does not roll or fall. Rolls are heavy, and dropping a roll may
When handling the roll, be careful not to soil the printing surface. This may affect the printing quality. We recommend
wearing clean cloth gloves when handling rolls to protect the printing surface.
Use scissors or a cutting tool to cut the edge of the roll paper if it is uneven, dirty, or has tape residue. Otherwise, it
may cause feeding problems and affect the printing quality.
Be careful not to cut through any barcodes printed on the roll.
Align the edges of the paper on both ends of the roll. Misalignment
may cause feeding problems.
For details on supported sizes and types of rolls, see " Paper Sizes " or the Paper Reference Guide .
(→"Paper Sizes," User's Guide) , (→"Types of Paper," User's Guide)
To view instructions as you attach the Roll Holder , press the Navigate button.
Lift the Holder Stopper lever (a) from the shaft side to
unlock it. Holding the Holder Stopper at the position
indicated (b), remove it from the Roll Holder .
Attaching the Roll Holder to Rolls
Attach the roll holder to rolls as follows.
Using rolls with a 2-inch paper core
2-Inch Paper Core Attachment (a)
Using rolls with a 3-inch paper core
3-Inch Paper Core Attachment #1 (b)
3-Inch Paper Core Attachment #2 (c)