Loading Sheets in the Printer
Load sheets in the printer as follows.
•
Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.
•
Load the paper straight. Loading paper askew will cause an error.
•
Loading sheets when a roll is already loaded in the printer may
cause jams. We recommend removing rolls before loading sheets.
(→
, Removing the Roll from the Printer)
To prevent the roll from unwinding if you leave it loaded, wrap a
sheet of paper around the roll and tape it.
•
Before loading sheets, make sure the printer is clean inside the Top Cover and around the Ejection Guide . If these
areas are dirty, we recommend cleaning them in advance. (→
•
Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
1
Select sheets as the paper source.
•
If a print job was received
Sheets are automatically selected, and the media type
and size specifi ed by the print job are shown on the
Display Screen .
Press ▲ or ▼ to select Load Paper , and then press the
OK button.
•
If no print job was received
1.
Press the Load button.
2.
Press ▲ or ▼ to select Load Cut Sheet , and then
press the OK button.
•
If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press ▲ or ▼ to select Yes , and then press the OK button. Remove the paper and go to the next step.
2
Lift the Release Lever and open the Top Cover .
, If Paper is Soiled)
20