Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual page 49

Error Message
PaprWidth Mismatch
Cannot feed paper.
Rel lever is in wrong position.
Cause
When Detect Mismatch in the
Control Panel menu is set to
Pause or Warning , the width of
the loaded roll does not match the
width specified in Fit Roll Paper
Width in the printer driver.
A paper jam occurred in the printer
during printing.
The Release Lever is up.
49
Corrective Action
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However, note that this error may cause paper jams
and affect the printing quality.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
Follow these steps to replace the roll to match the
width specified in the printer driver.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button to remove the roll.
(→ , Removing the Roll from the Printer)
(→"Removing the Roll Holder from Rolls," User's
Guide)
2. Replace the paper with paper compatible for
borderless printing.
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Rolls in the Printer)
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box
displayed when you select Fit Roll Paper Width in
the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
1. Lift the Release Lever and remove the jammed
paper.
(→ , If Roll Paper Jams)
(→ , If a Sheet Jams)
2. Load paper.
3. Lower the Release Lever .
4. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→ , Loading Rolls in the Printer)
(→ , Loading Sheets in the Printer)
Lower the Release Lever .
If the error occurs again, turn off the printer and wait a
while before restoring power.
Error Messages