Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual page 45

Error Message
Paper mismatch
Paper loaded askew.
Cause
You tried to print a test pattern
for printer adjustment on several
sheets, but sheets of different
types or sizes of paper were used.
Paper loaded crooked was
detected when the paper was
advanced.
45
Corrective Action
When printing a test pattern for adjustment, use
sheets of the same size and type of paper, in the
required quantity.
Press ▲ or ▼ to select Change Paper , press the OK
button, and replace the paper.
(→"Loading and Printing on Sheets," User's Guide)
The printer now starts printing the test pattern.
Replace the paper as follows and perform adjustment
again.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Replace the paper.
(→"Loading and Printing on Sheets," User's Guide)
3. Execute adjustment again from the control panel
menu.
Follow these steps to reload the roll.
1. Lift the Release Lever .
2. Adjust the right edge of the roll to make it parallel to
the orange Paper Alignment Line .
3. Lower the Release Lever .
(→ , Loading Rolls in the Printer)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer, push the roll firmly in
until it touches the Roll Holder flange, and reload the
Roll Holder in the printer.
(→ , Attaching the Roll Holder to Rolls)
Follow these steps to reload the sheet.
1. Lift the Release Lever .
2. Pull out the sheet.
3. Lower the Release Lever .
4. Adjust the right edge of the sheet to make it parallel
to the right Paper Alignment Line and the trailing
edge of the sheet to make it parallel to the paper
alignment line under the Paper Retainer .
(→ , Loading Sheets in the Printer)
Error Messages