Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual page 44

Error Messages
Error Message
The paper is too small.
The paper is too small.
Replace paper with A4/LTR
(vertical) or larger
The paper is too small.
Replace roll with 10 in. wide or
larger roll.
Cause
When Detect Mismatch in the
Control Panel menu is set to
Pause or Hold Job , paper smaller
than the size specified in the
printer driver is loaded.
When Detect Mismatch in the
Control Panel menu is set to
Warning , paper smaller than the
size specified in the printer driver
is loaded.
The loaded paper is too small.
(When you are attempting to print
a test print sheet or other printer
status information.)
The loaded paper is too small.
(When you are attempting to print
a test print sheet or other printer
status information.)
Corrective Action
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However, note that this error may cause paper jams
and affect the printing quality.
Adjust the paper size setting in the printer driver to
match the size loaded in the printer as follows.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Change the paper size setting in the printer driver to
the size loaded in the printer and try printing again.
Replace the loaded paper with paper of a size that
matches the size setting in the printer driver as
follows.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button to stop printing.
2. Replace the loaded paper to match the paper width
setting in the printer driver and try printing again.
You can continue to print, but note that this error may
cause problems in the printing results.
Replace the paper with paper of A4/Letter (vertical)
size or larger as follows.
1. Press ▲ or ▼ to select Change Paper , press the
OK button, and remove the paper.
(→ , Removing Sheets)
2. Switch to paper A4/Letter (vertical) or larger.
(→"Loading and Printing on Sheets," User's Guide)
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
Replace the roll with a roll 10 inches in width or larger
as follows.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button to remove the roll.
(→ , Removing the Roll from the Printer)
(→"Removing the Roll Holder from Rolls," User's
Guide)
2. Replace the roll with a roll 10 inches wide or larger.
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Rolls in the Printer)
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
44