Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual page 43

Error Message
Rewinding error.
Turn on the media take-up unit.
Media take-up unit ready.
Multi-sensor error
Maint. cart. The level is low
Maintenance cartridge problem.
Maintenance cartridge full.
No maintenance cartridge.
Wrong maintenance cartridge.
No Maintenance Cartridge
capacity.
Cause
There is some foreign object near
the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor
is soiled and the roll cannot be
detected.
The roll is out of range of detection
by the Media Take-up Unit
sensor.
The Media Take-up Unit sensor is
damaged.
A paper jam has occurred and the
roll cannot be rewound.
The Media Take-up Unit was off
when you selected Enable for
Take-up Reel .
The Take-up Reel setting in
the printer Set./Adj. Menu was
changed from Enable to Disable ,
but a print job was received before
the roll was removed.
Direct sunlight or strong lighting
may be shining on the printer and
causing the sensor to malfunction.
The performance of a sensor
inside the printer may be impaired.
The Maintenance Cartridge is
almost full.
An incompatible or used
Maintenance Cartridge has been
installed.
The Maintenance Cartridge is full.
The Maintenance Cartridge is not
installed.
A Maintenance Cartridge for
a different model of printer is
installed.
The Maintenance Cartridge cannot
absorb enough ink for Printhead
cleaning or other operation.
43
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(→ , Loading Rolls in the Printer)
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit .
Press the OK button to clear the error.
Turn on the Media Take-up Unit .
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
The mode switches from take-up mode to regular
mode after you change the Take-up Reel setting
in the Set./Adj. Menu from Enable to Disable and
lift the Release Lever to remove a roll, or after you
execute Paper Cutting .
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Contact your Canon dealer for assistance.
You can continue to print, but prepare a new
Maintenance Cartridge to use when the message for
replacement is displayed.
Install an unused Maintenance Cartridge specified for
use with the printer.
(→ , Replacing the Maintenance Cartridge)
After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Install the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Replace it with the Maintenance Cartridge for your
particular model.
After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Error Messages