Canon imagePROGRAF iPF8300S Basic Guide No.2 Basic Manual page 38

Error Messages
Error Message
Cannot execute this command.
Use other paper.
Cannot cut this paper.
This paper cannot be used as
size is not supported.
Cause
Paper compatible with color
calibration is not loaded.
There are sheets left on the
Ejection Guide .
There is a foreign object by the
Output Tray , obstructing the
Cutter Unit .
You are not using the printer under
the recommended environmental
conditions for the paper.
You are using paper that is not
compatible with automatic cutting.
In other cases, the Cutter Unit
may be damaged.
Paper that is too large for the
printer has been loaded.
Paper that is too small for the
printer has been loaded.
Paper has been loaded that is too
small to print the test pattern for
printhead adjustment or nozzle
checking.
38
Corrective Action
1. Press the OK button to clear the error.
2. Load paper that is compatible with color calibration.
See the Paper Reference Guide .
(→"Types of Paper," User's Guide)
Always make sure the loaded paper matches the
type of paper in the printer paper settings. Adjustment
cannot be completed correctly unless the loaded
paper matches the settings.
1. Lift the Release Lever and remove the paper.
2. Load paper.
3. Lower the Release Lever .
4. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
(→ , Loading Rolls in the Printer)
1. Lift the Top Cover and remove the foreign object.
2. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions, see
the Paper Reference Guide .
(→"Types of Paper," User's Guide)
1. Specify Manual as the cutting method and use
scissors or a cutting tool to cut the roll.
(→"Specifying the Cutting Method for Rolls," User's
Guide)
For information about paper that is compatible with
automatic cutting, see the Paper Reference Guide .
(→"Types of Paper," User's Guide)
2. Lift the Release Lever and remove the paper.
Contact your Canon dealer for assistance.
Lift the Release Lever and load paper of the correct
size.
(→"Paper Sizes," User's Guide)
Lift the Release Lever and load paper of the correct
size.
(→"Paper Sizes," User's Guide)
Lift the Release Lever and load unused paper A4/
Letter (vertical) or larger. More than one sheet may be
required depending on the adjustment.