S P E E D S E N S O R H O R S T A S S E M B - Specialized LEVO 2022 Technical Manual

SPEED SENSOR HORST ASSEMBLY
1
B A
# PART NAME PART NUMBER
A Speed Sensor Cable S216800025
B Speed Sensor Grommet
S216800021
C Speed Sensor Bolt
D Speed Sensor Magnet Bolt
S194200016
E Speed Sensor Magnet
WARNING! Dirt and/or metal debris may accumulate on the speed sensor magnet. Too much accumulation may
result in interruptions in motor support and/or inaccurate speed readings. Regularly check your speed sensor
magnet for an accumulation of dirt and/or metal debris, and clean accordingly. The frequency of the cleaning
depends on your riding conditions, ride frequency and/or brake pad material. Removing metal debris may
require the use of a magnet stronger than the speed sensor magnet.
The speed sensor must be installed before assembling the horst pivot flip chip.
2022
TECHNICAL GUIDE
2
QTY SPEC
1
1
1 M4 x 8 mm x 0.7mm p
2 M5 x15 mm x 0.8 m p
1
3
D E
C
TORQUE
TOOL
Nm in-lbf
N/A N/A N/A
N/A N/A N/A
3 mm hex 1 9
T25 Torx 6.2 55
„ 1: Open the grommet and place it over the speed sensor cable.
2: Slide the speed sensor into the chainstay at the dropout.
„
3: Using a 3 mm hex key, tighten the screw, then torque to specification.
„
When assembling the rear brake disc, the speed sensor magnet must be installed on the rotor. Four of the six bolts are standard rotor bolts.
„
The remaining two bolts (M5 x 0.8 pitch x 15 mm length, with a countersunk flat head) attach the speed sensor magnet to the rotor.
COMMENT
16
PAGE