Canon VB-C60 Operation Manual page 104

Motion Detection Setting Tool
(1)Setting Frame Rate
When this check box is selected, the camera's frame rate for motion detection can be
changed. Enter a desired rate in a range of fps 0.5 to 30.0.
(2)Enable preset selection
When this check box is selected, you can select the camera position using a preset.
Note
The value set in [Maximum Frame Rate: Image Transmission] (
the frame rate set by this tool.
Tip
If the network load is heavy, the specified frame rate may not be achieved.
By setting a lower frame rate, the video extracted from the captured video will be included
in the scope of motion detection. This way, you can also perform motion detection for slow-
moving subjects, etc.
The frame rate set here is applied only to motion detection.
Presets outside the view restriction are not shown in the preset list.
3. Set the motion detection area ([Area] tab).
Up to four motion detection areas can be created, where the frame of each area can be
resized/moved by dragging. To resize the frame, drag " " at four corners/on four sides. To
move the frame, drag a point inside the frame. You can also set a separate motion detection
level for each area. This camera lets you set the motion detection level while playing the video
recorded in the [Live] tab (
2-38
(1)
(2)
P. 2-43).
P. 1-22) must be greater than