ABB REB500 Operation Manual page 49

1MRK 500 124-UEN
3.6.3.5
Operation Manual
Distributed busbar protection REB500
New Signal
Fig. 3.1 Configuration / Binary module - Inputs - New signal
The button "New signal" opens a dialog with a list for selecting and adding a new
signal.
Clicking on the arrow to the right of the "Signal type" field opens a list of available
signals. The effective list depends on the functions ordered by the user. The list can
include as a maximum the following groups:
• General signals
• Busbar protection (BBP)
• Breaker failure protection (BFP)
• End fault protection (EFP)
• Time-overcurrent protection (OCDT)
• Disturbance recorder (DR)
• CB pole discrepancy protection (PDF)
• Voltage release (UV)
Clicking on the arrow button to the right of the signal name field opens a list of the
signals available according to the filter group and device selected.
Signals that can only be assigned once will disappear from the list as soon as the
user has assigned them.
The new signal can be configured as described above.
Outputs
The procedures for configuring binary inputs and outputs are almost identical, in
particular creating new signals and deleting existing ones. Therefore only the
differences are dealt with in this section.
Section 3
HMI500
41