Download Print this page

Enwork Ligouri TI0061 Installation Instructions Manual

Touchdown table

Advertisement

Quick Links

Ligouri
Touchdown Table
Installation Instructions
TI0061
06/17/21 - Rev A

Advertisement

loading
Need help?

Need help?

Do you have a question about the Ligouri TI0061 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Enwork Ligouri TI0061

  • Page 1 Ligouri Touchdown Table Installation Instructions TI0061 06/17/21 - Rev A...
  • Page 2 INSTALLATION GUIDE 1) Parts and Fasteners Included Corner Leg Assembly (4x) Mid-Leg Assembly (0x, 2x, or Tube for Depth (2x) LNA-2003-x Tube for Width (2x, 4x, or 6x) 3/8-16 x 0.75 Button Head #8 x 0.75 Pan Head Phillips Socket Cap Screw (16x, 24x, Wood Screw LNA-2003-x or 32x)
  • Page 3: Tools And Supplies Required

    INSTALLATION GUIDE 2) Tools and Supplies Required Drill #2 Phillips Drive Bit 7/32” Hex Bit Socket or Allen (magnetic tip preferred) Tape Measure Level...
  • Page 4 INSTALLATION GUIDE Overview 3) Assembly: Multi-Piece Table (Pages 6-8) One-Piece Table (Pages 4-5)
  • Page 5 INSTALLATION GUIDE One-Piece Table 4) Assembly: 1. Attach the Corner Leg Assemblies to a Tube (depth) using the 3/8-16 x 0.75 Button Head Socket Cap Screws. Keep small holes in Tube facing upwards. Note: Finger tighten for now. Figure 4.1 2.
  • Page 6 INSTALLATION GUIDE One-Piece Table 4) Assembly: 4. On a non-marring surface, center the assembled base on the Top and attach using the #8 x 0.75 Pan Head Phillips Wood Screws. Note: Screws go through clearance holes in bottom of the Tube. Figure 4.4 5.
  • Page 7 INSTALLATION GUIDE Multi-Piece Table 5) Assembly: 1. Attach the Corner Leg Assemblies to a Tube (depth) using the 3/8-16 x 0.75 Button Head Socket Cap Screws. Keep small holes in Tube facing upwards. Note: Finger tighten for now. Figure 5.1 2.
  • Page 8 INSTALLATION GUIDE Multi-Piece Table 5) Assembly: 4. Fully tighten all the 3/8-16 x 0.75 Button Head Socket Cap Screws. Figure 5.4 5. On a non-marring surface, connect your Top pieces together using the Zipbolt Tight Joint connector. Note: Make sure pieces are flush and aligned before fully tightening the Zipbolt.
  • Page 9 INSTALLATION GUIDE Multi-Piece Table 5) Assembly: 7. With the Table flipped in the upright position, level the Table using the glides in the bottom of each leg. Figure 5.7...
  • Page 10 12900 Christopher Drive Lowell, MI 49331 800.815.7251 www.enwork.com Specifications subject to change without notice.