Unpack The Fixture; Remove The Yoke - ETC Cyberlight LED User Manual

Unpack the Fixture

The Cyberlight LED shipping carton includes:
one (1) Cyberlight LED automated luminaire
•
one (1) power cord (powerCON TRUE1 TOP input to bare ends)
•
one (1) yoke with yoke installation hardware (the luminaire ships with the yoke attached)
•
one (1) stainless steel safety cable with locking carabiner
•
Visually inspect the shipping carton for damage that may have occurred during transit. If the
shipping carton shows signs of damage, document the damage fully before unpacking the
contents. Documentation of any damage is helpful when reporting a claim with the carrier.
The luminaire weighs approximately 38 kg (84 lb). For your safety, ETC recommends that two
people unpack the luminaire from the shipping carton. Use the handles on the sides of the
luminaire to lift the luminaire from the shipping carton.
Do not discard the shipping carton and packaging materials. The carton and packing materials
are specifically designed to protect the fixture during transport and will be useful if you need
to ship the fixture, including transporting the fixture for service.

Remove the Yoke

The Cyberlight LED ships with the yoke installed in a shipping configuration to help protect the
fixture from damage during transit. Remove the yoke from the fixture after you unpack the
fixture. See Yoke Assembly on page 8
Tool needed:
8.0 mm hex key
•
1. Loosen but do not remove the yoke locking knobs on each side of the yoke.
2. Using the 8.0 mm hex key, remove the yoke pivot screws and washers from each side of the
yoke.
Save the screws and washers. You will need them when you attach the yoke to the fixture
in its operating configuration.
3. Lift the yoke from the fixture.
Unpack the Fixture
for information about the components of the yoke.
6