Raider RD-KMD01J User Manual page 18

18 www.raider.bg
• After work every day, wash the air filtar.Ako
chemicals stick to the foam segment may impair
engine performance, please pay special attention!
• After washing the foam filter segment with
gasoline, gasoline Squeeze it and put it back into
its body.
• The distance between the electrodes of the
spark plug must be 0.6-0.7 mm. Please check this
space often, if it is too big or too small, adjust it
properly, as shown in Fig.16.
4. Caring for long life
• Clean the outside of the machine. Cover metal
parts with oil stain.
• Remove the spark plug. Pour 15-20d engine
oil into the cylinder. The oil should be specifically
for two-stroke gasoline engine. Bring the piston to
highlight his point, then tighten the candle again.
• Loosen the two wing nuts. Remove the
chemical tank. Clean the valve reservoir dust and
wash inside and out. If you remain chemical dust
valve will not work correctly. Place the chemical
container and tighten lid.
• Remove spray parts, wash them and collect
separately.
• It is recommended to empty the fuel from the
tank and carburetor.
• Cover with plastic wrap machine and then
storing in a dry and dusty place.
Important for the user:
The engine must use a mixture stroke. The ratio
between gasoline and oil are determined by the
instructions of the oil to be two-stroke (absolutely
forbidden the use of other oils).
The engine must be operated without load after
starting and before stopping for about 3-5 minutes
is prohibited without the engine load at high speed
to avoid damage to engine parts or the case. It also
prohibits the sudden stopping of the engine when it
runs at high speed.
To avoid fire engine should be stopped and be
located away from sources of ignition when fueling.
Smoking during charging is prohibited.
fig. 16