Table of Contents
Advertisement
Available languages
Available languages
Knocking
No connection
noise
with the fuel
hose
Bad fuel
Deposits on
combustion
chamber
Moving parts are
scored and worn
3. The engine stops
Problem
Reason
Spark plug
cable is loose
The engine
The piston is
blocked
stopped
suddenly
The spark
plug is burned
Fuel runs out
Carburetor is
blocked
Vent the tank
The engine
is half blocked
stops slower
The fuel is
mixed with
water
4. The engine stops hard
Problem
Reason
Throttle lever
The sting of
is in the down
gas is too
position, but
short (low
the engine still
speed is high)
running
5. Spraying
Problem
Reason
There is not
Off the control
absolutely
valve or nozzle
chemical
is clogged
spraying or it
The mixture
interrupts
tube clogged
No pressure or
pressure is low
in the scheme
Leakage of
Fragmentary
chemicals
plate is
inserted
incorrectly
Some of the
connections
are loose
Contact
replace the fuel
Clean up
Check and
replace
Solution
Connect it firmly
Replace the
piston and fix it
Clean it
Load fuel
Clean it
Clean it
change fuel
Solution
Adjust the cable
as described in
Fig. 10
Solution
MACHINE
Clean it
Clean it
the solution tank. Wash the tank and all other parts.
Tighten the lid of
the tank and turn
clear plate and sprayed inside and outside the tank.
the two wing nuts
securely
Put it right
running at minimum power for 2-3 minutes.
of engine problems h, so the fuel system should be
cleaned frequently.
Tighten
carburetor long time, it can kleyasa and clog the
fuel system. This is the reason the engine does not
work well. Once the machine has not worked one
week all the fuel must be drained.
6. Aerial spraying
Problem
Reason
The flap of the
dust may not
open
Powder or
granules are
Dust not
mixed with
discharge or
impurities
discharge is
intermittent
Powder or
granules have
become lumps
Wet granules or
powder
The flap of the
dust can not be
closed
The flap of the
dust does not
The flap of the
work well
dust is blocked
by a foreign
body
Bracket on the
bottom of the
chemical tank is
loose
Expiry of dust
Sealing rubber
seal dusty
saucer damaged
Release
Valve control
of dust is
device is not
uncontrollable
working properly
OPERATION AND CARE FOR LONG LIFE OF
1. Operation or spraying
• After spraying clear any residue or dust from
• After aerial spraying or dispersing granules,
• After work loose plate of the chemical tank.
• After cleaning the machine left the engine
2. Operation of the fuel system
• Fuel mixed with water or dust is a major cause
• If the remaining fuel stays in the tank and
3. Operation of the air filter and spark plug
17
Solution
Adjust the
valve cable
Clean it
Crush clods
Dry it
Настроте
жилото на
клапата
Clean it
Tighten
Replace with
new
Fix it
Advertisement
Table of Contents
